FunFly-65 - ERC's FunFly 65
puts the FUN in sunday flying and smile on everyone's face. This sweetie is loaded with the
features found only in our competitors' higher priced airplances, and has a few cool exclusive
features. Buy one of these and show your 'Stick-flying buds a thing or two! Check these hot
features:
The airframe structure uses a patented composite material that resists impact and
compression damage 10 times better than conventional balsa construction typically used in these
types of airplanes! It's used in several of our aircraft for strength enhancement.
This bird has a symmetrical airfoil for improved aerobatic capability.
Long fuselage moment makes for graceful flying and good ground handling.
Lots of ground clearance from the landing gear design to help keep your prop
out of the dirt when you're having fun!
Comes with and wingtip plates as built-in skids. (photo 3)
Aileron tip cut-backs to minimize damage while 'wing dragging'. (photo 3)
A BIG 12oz. fuel tank.
It's set up as a taildragger from the factory, so you don't have to both with typical conversions! Easily flys with any standard radio system and
.60+ glow engine.
Professionally built & covered, all surfaces are pre-hinged.
The kit is supplied with all the hardware needed for quick assembly.
Specifications:
- Wingspan: 64-1/4 in (1630 mm)
- Length: 64-3/4 in (1645 mm)
- Wing Area: 849-1/2 sq. in
- Flying weight: 6.5-7.25 lbs
- Engine Required: .60-.90 2c, .82-1.20 4c (not included)
- Wing Loading: 19.2-21.2 oz/ft
- Radio required: 4 Channels, 5 std servos (see our RADIOS section for servos)
